Protection Engineer

Winstar Electromechanical Works WLL

Any Engineer graduate in Electrical or Power Systems

Minimum 3 years of relevant experience

Graduate Engineers with minimum 3 years of experience in testing & commissioning of

Configure & test the Back up Numerical relays of various makes such as Areva, Siemens, ABB, Schneider, GE.

Configure & test all the auxiliary relays.

Configure & test Overcurrent/Earth fault relays.

Configure & test Guard relays, Pilot end supervision relays.

Configure & test Cable differential & Transformer differential relays.

Configure & test Restricted Earth fault relays.

Configure & test Busbar Protection relays.

Configure & test TAPCON, Eberele relays.

Configure & test Synchronization relays.

Configure & test Motor protection & Feeder protection relays.

Configure & test Bay Control Units (BCUs) of Siemens, ABB, Areva, etc.

Should possess knowledge about Main relays.

Experienced in Testing & Commissioning of substation control & protection at sites.

Should be able to independently check & verify the Schemes of the System interlocks.

Should be well versed with Load shedding scheme, Voltage selection scheme, Trip circuit schemes, stability & sensitivity checks, BI checks.

Should have experience & knowledge on RTCC panels.

Should have knowledge on Bus bar & Transformer stability checks.

Should have knowledge & experience in integrateion of Protection systems with SCS/DCS systems with IEC61850.

Should be able to handle the SAT activities with the team members.

Should be able to clarify & handle the consultant & end client to complete the activities without any snags/site notes.

Should communicate clearly about any technical lags/hiccups in the schemes/circuits.

• Experience

  3 - 9 Years

• No. of Openings

  5

• Education

  B.E

• Role

  Protection Engineer

• Industry Type

  Manufacturing / Production / Quality

• Gender

  [ Male / Female ]

• Type of Job

  Full Time

• Work Location Type

  Work from Office