lop Civil and Structural bill of material; Prepare Layouts and detail aration, Checking and approval of Bar Bending Schedules, co-ordination with Vendor. 2. 3D modeling of RCC foundations, Piles, Pile caps, Structural Steel using Tekla, Extraction of GA drawings. Development of RCC details, Base plate and Anchor bolts, Bill of material. modeling, drawing extractions and Development of Structural Steel details, Piperacks, Technological Structures, Shelters, Grade Mounted platforms, Vessel mounted platforms, Pipe supports, Equipment foundations, Roads and . Perform calculations and layouts including 2D and 3D models with adequate dimensions necessary to assist the Engineering disciplines and Fabrication/Construction personnel including preparation of topographic layouts, earthworks/excavation drawings, boreholes locations, fencing, paved roads and drainage, underground piping and foundations, architectural and conceptual building drawings, control room layouts, substation layouts, machinery shelters, service platforms, pipe racks, pump foundations, vessel and vessel platform foundations, columns and other Civil/structural . Perform layout clash/interface checks, identify conflicts, take corrective action in coordination with other engineering discipline inputs. 6. Issue engineering drawings and layouts for Inter-Discipline Checks (IDCs) coordinate with other engineering discipline in the integration of technical data inputs. Prepare final layouts and drawings integrating inputs provided by other engineering disciplines. Consult and make recommendations to Engineers on feasibility of design plans and . Estimation and preparation of material take offs (MTOs), review vendor drawings, ensure vendor specifications are in full compliance with contract/ project requirements. 8. Prepare Red-line markups, resolution of site queries from Construction and fabrication shop queries / TQs. Preparation of detail sketch